Specifications; Attachments/Accessories; Operation; Operating The Cargo Box - Toro 07390 Workman HDX-Auto Operator's Manual

Specifications

Note: Specifications and design are subject to change
without notice.
Dimensions
Overall Width 160 cm (63 inches)
without bed—326 cm (128 inches);
with full bed—331 cm (130 inches);
Overall Length
with 2/3 bed in rear mounting
location—346 cm (136 inches)
Model 07390—866 kg (1905 lb);
Base Weight (Dry) Model 07390H—866 kg (1905 lb);
Model 07390TC—887 kg (1951 lb)
Rated Capacity Model 07390—1498 kg (3295 lb);
(includes 91 kg (200 Model 07390TC—1477 kg (3249 lb);
lb) operator, 91 kg Model 07090H—1498 kg (3298 lb)
(200 lb) passenger and
loaded attachment)
Maximum Gross 2363 kg (5210 lb)
Vehicle Weight
Tow Capacity Tongue weight: 272 kg (600 lb);
Maximum trailer weight: 1587 kg
(3,500 lb)
Ground Clearance 18 cm (7 inches) with no load
Wheel Base
118 cm (70 inches)
Wheel Tread (center Front: 117 cm (46 inches); Rear: 121
line to center line) cm (48 inches)
Height
191 cm (75 inches) to top of ROPS

Attachments/Accessories

A selection of Toro approved attachments and accessories is
available for use with the machine to enhance and expand
its capabilities. Contact your Authorized Service Dealer or
Distributor or go to www.Toro.com for a list of all approved
attachments and accessories.

Operation

Note: Determine the left and right sides of the machine
from the normal operating position.
CAUTION
You may be injured or killed if the raised bed of the
machine falls on you.
Before working under a raised bed, remove any
cargo and position the safety support on the fully
extended cylinder rod.

Operating the Cargo Box

Raising the Cargo Box
WARNING
Driving the vehicle with the cargo box raised may
cause the vehicle to tip or roll easier. The box
structure may become damaged if you operate the
vehicle with the box raised.
• Only operate the vehicle when the cargo box is
down.
• After dumping a load, lower the cargo box.
CAUTION
If a load is concentrated near the back of the cargo
box when you release the latches, the tailgate may
unexpectedly tip open, injuring you or bystanders.
• Center the load in the cargo box, if possible.
• Ensure that no one is leaning over the box or
standing behind it when releasing the tailgate
latches.
• Remove all cargo from the box before lifting the
box up to service the machine.
1. Set the parking brake; refer to
2. Start the engine; refer to
3. Move the lever backward to raise the cargo box to the
desired position.
Note: If you are maintaining the machine and need to
have the box raised, secure the box with the bed safety
support; refer to
36).
19
Parking Brake (page
Starting the Engine (page
(Figure 18).
Using the Bed Safety Support (page
16).
27).