Checking The Interlock System; Transporting The Machine - Toro 07390 Workman HDX-Auto Operator's Manual

Checking the Interlock System

Service Interval: Before each use or daily
The purpose of the interlock system is to prevent the engine
from cranking or starting unless the brake pedal is pressed
and the hydraulic lift lever in the Neutral position.
CAUTION
If safety interlock switches are disconnected or
damaged, the machine could operate unexpectedly
causing personal injury.
• Do not tamper with the interlock switches.
• Check the operation of the interlock switches
daily and replace any damaged switches before
operating the machine.
Note: Refer to Attachment Operator's Manual for procedures
on checking the attachment interlock system.
Verifying the Hydraulic Lift Lever
Interlock Switch
1. Sit on the operator's seat and set the parking brake.
2. Move the shift lever to the Neutral position, ensure
that the hydraulic lift lever is in the center position.
3. If Non-TC model with the High Flow Hydraulic Kit
(option) or TC model, set the high flow hydraulic
switch to the Off position.
4. Press brake pedal.
5. Move the hydraulic lift lever forward and rotate the
ignition key clockwise to the start position.
If engine cranks or starts, there is a malfunction in the
interlock system that must be repaired before operating
vehicle.
Verifying the Brake Pedal Interlock
Switch
1. Sit on the operator's seat and set the parking brake.
2. Move the shift lever to the Neutral position, ensure
that the hydraulic lift lever is in the center position.
3. If Non-TC model with the High Flow Hydraulic Kit
(option) or TC model, set the high flow hydraulic
switch to the Off position.
4. Rotate the ignition key clockwise to the start position.
Note: Do not press the brake pedal
If engine cranks or starts, there is a malfunction in the
interlock system that must be repaired before operating
vehicle.
Verifying the High Flow Switch Interlock
Non-TC model with the High Flow Hydraulic Kit (option)
or TC model
1. Sit on the operator's seat and engage the parking brake.
2. Move the shift lever to the Neutral position and ensure
that the hydraulic lift lever is in the center position.
3. Set the high flow hydraulic switch to the On position.
4. Press brake pedal.
5. Rotate the ignition key clockwise to the start position.
If engine cranks or starts, there is a malfunction in the
interlock system that must be repaired before operating
vehicle.

Transporting the Machine

For moving the machine long distances, use a trailer. Make
sure that the machine is secured to the trailer. Refer to
35 and Figure 36 for the location of the tie-down points.
Important: Trailers weighing over 680 kg (1500 lb) are
required to be equipped with trailer brakes.
Note: Load the machine on the trailer with the front of the
machine facing forward. If that is not possible, secure the
hood of the machine to the frame with a strap or remove the
hood and transport and secure it separately, otherwise the
hood may blow off during transport.
1. Eye hole in frame (each side)
1. Axle
29
Figure 35
Figure 36
2. Hitch plate
Figure