Lubrication
Greasing the Bearings and the
Bushings
Service Interval: Every 100 hours (lubricate more frequently
in heavy duty applications).
Lubrication type: No. 2 general-purpose, lithium-based
grease
Important: When greasing the drive shaft universal
shaft bearing crosses, pump grease until it comes out
of all 4 cups at each cross.
1. Wipe each grease fitting clean so that foreign matter
cannot be forced into the bearing or bushing.
2. Connect the grease gun to the grease fitting.
3. Pump grease into each bearing or bushing.
4. Wipe off any excess grease.
The grease fitting locations and quantities are as follows:
•
Ball joints (4); refer to
•
Pivot mounts (2); refer to
•
Steering cylinder (2); refer to
•
Tie rods (2); refer to
Figure 48
Figure 48
Figure 48
Figure 48
Figure 48
Spring tower (2); refer to
•
Brake (1); refer to
•
Throttle (1); refer to
39
Figure 49
Figure 49
Figure 50
Figure 50
Figure 50