Specifications - Makita DFR440X Instruction Manual

ENGLISH (Original instructions)
1-1. Red indicator
1-2. Button
1-3. Battery cartridge
2-1. Star marking
3-1. Lever
3-2. Stopper base
3-3. Plate
3-4. Casing
4-1. Stopper base
4-2. Casing
4-3. Adjusting knob
5-1. Switch trigger
6-1. Reversing switch lever

SPECIFICATIONS

No load speed (min
• Due to our continuing program of research and development, the specifications herein are subject to change without notice.
• Specifications and battery cartridge may differ from country to country.
• Weight, with battery cartridge, according to EPTA-Procedure 01/2003
Intended use
The tool is intended for screw driving in wood, metal
and plastic.
Noise
The typical A-weighted
according to EN60745:
Model DFR450X
Sound pressure level (L
Uncertainty (K) : 3 dB (A)
The noise level under working may exceed 80 dB (A).
Wear ear protection
Vibration
The vibration total
determined according to EN60745:
Model DFR450X
Work mode: screwdriving without impact
Vibration emission (a
Uncertainty (K) : 1.5 m/s
The declared vibration emission value has been
•
measured in accordance with the standard test method
and may be used for comparing one tool with another.
Explanation of general view
7-1. Casing
7-2. Thumb screws
8-1. Bit
8-2. Dust cover
8-3. Plane bearing
9-1. Feeder box
9-2. Screw strip
9-3. Screw guide
10-1. Driving position
12-1. Reverse button
13-1. Hook
15-1. Wall
15-2. Stopper base
Model
Screw strip
-1
)
Overall length
Net weight
Rated voltage
noise level determined
) : 78 dB (A)
pA
value (tri-axial vector
2
) : 2.5 m/s or less
h
2
DFR440X
1.7 kg
D.C. 14.4 V
ENE033-1
The declared vibration emission value may also be
•
used in a preliminary assessment of exposure.
WARNING:
ENG905-1
The vibration emission during actual use of the
•
power tool can differ from the declared emission
value depending on the ways in which the tool is
used.
Be sure to identify safety measures to protect the
•
operator that are based on an estimation of
exposure in the actual conditions of use (taking
account of all parts of the operating cycle such as
the times when the tool is switched off and when it
is running idle in addition to the trigger time).
ENG900-1
For European countries only
sum) EC Declaration of Conformity
Makita declares that the following Machine(s):
Designation of Machine:
Cordless Auto Feed Screwdriver
Model No./ Type: DFR450X
Conforms to the following European Directives:
2006/42/EC
They are manufactured in accordance with the following
ENG901-1
standard or standardized documents:
EN60745
4
16-1. Limit mark
17-1. Casing
17-2. Thumb screws
18-1. Front cover
18-2. Screws
19-1. Spring
19-2. Arm
19-3. Recessed part
20-1. Carbon brush cap
21-1. Hole
21-2. Carbon brush cap
DFR450X
4 mm x 25 mm - 41 mm
4,000
369 mm
2.0 kg
D.C. 18 V
ENH101-18