Advertisement
71. Attach the engine starter relay block clip to the
vehicle frame.
ENGINE STARTER
RELAY BLOCK
ENGINE STARTER
HARNESS RELAY
BLOCK CLIP
72. Bundle up the excess antenna cable and secure it to
the engine starter harness and the vehicle harness
with the loosely installed wire tie.
ENGINE STARTER
VEHICLE
HARNESS
HARNESS
73. Secure the antenna cable to the engine starter
harness with two additional wire ties.
20 of 24
VEHICLE
FRAME
WIRE TIE
(Loosely secured.)
TIES
Bundle up the
antenna cable.
74. Under the hood, locate the area where the caution
label will attach. Using isopropyl on a shop towel,
clean the hood where the caution label will attach.
CAUTION
LABEL
ADHESIVE
BACKING
6D18601Y
75. Attach the caution label to the hood in the area
shown.
76. Reinstall all removed parts. Check that all clips and
other fasteners are installed securely. Take care not
to pinch the airbag with the clip during reinstallation
of the front pillar trim. Do not push excessively on the
front pillar trim.
77. Reconnect the negative cable to the battery.
78. Enter the customer's radio anti-theft code, and reset
the radio station presets.
79. Reset the clock on models without navigation.
80. Do the REMOTE ENGINE STARTER
REGISTRATION (page 21) and FUNCTION
CHECK (page 24).
WIRE
6D18620Y
AII 35365 (0708)
HOOD
© 2007 American Honda Motor Co., Inc. – All Rights Reserved.
732902AY
Advertisement
