Mounting Of Handle; Mounting Of Protector - Makita EM2500L Instruction Manual

MOUNTING OF HANDLE

CAUTION: Before doing any work on the equipment, always stop the engine
and pull the spark plug connector off the spark plug.
Always wear protective gloves!
CAUTION: Start the engine only after having assembled it completely.
– Put the handle holder (1) and handle (2) on to the shaft.
– Make sure that the handle assembly is not fitted farther than the arrow mark
(3).
– Fix and tighten them by four M5 × 30 bolts (4) and four M5 nuts (5).
Note: In some countries the handle may be non-­barrier type.

MOUNTING OF PROTECTOR

To meet the applicable safety standards, you must only use the tool/protector
combinations indicated in the table.
Always use genuine MAKITA cutter blades/nylon cutting head.
– The cutter blade must be well polished, and free of cracks breakages. If the
cutter blade hits against a stone during operation, stop the engine and check
the blade immediately.
– Polish or replace the cutter blade every three hours of operation.
– If the cutting tool hits against a stone during operation, stop the engine and
check the cutting tool immediately.
Star Blade
CAUTION: The appropriate protectors must always be installed for your own
safety and in order to comply with accident-prevention regulations.
Operation of the equipment without the guard installed is prohibited.
– Fix the protector (1) to the clamp (3) with two M6 × 30 bolts (2).
– When using the nylon cutting head, fit the protector (5) into the protector (1),
and tighten them with two screws (4).
Protector for metal blades
(3)
Nylon cutting head
9
(4)
(2)
(1)
(5)
Engine
Protector for cord cutter
(2)
(3)
(1)