Draytek Vigor2820 Series User Manual page 63

WAN
Src IP Start
Src IP End
Dest IP Start
Dest IP End
Dest Port Start
Dest Port End
Move UP/Move Down Use Up or Down link to move the order of the policy.
Click Index 1 to access into the following page for configuring load-balance policy.
Enable
Protocol
Binding WAN
interface
Src IP Start
Src IP End
Vigor2820 Series User's Guide
Use the drop-down menu to change the WAN interface.
Displays the IP address for the start of the source IP.
Displays the IP address for the end of the source IP.
Displays the IP address for the start of the destination IP.
Displays the IP address for the end of the destination IP.
Displays the IP address for the start of the destination port.
Displays the IP address for the end of the destination port.
Check this box to enable this policy.
Use the drop-down menu to choose a proper protocol for the WAN
interface.
Choose the WAN interface (WAN1 or WAN2) for binding.
Type the source IP start for the specified WAN interface.
Type the source IP end for the specified WAN interface. If this
field is blank, it means that all the source IPs inside the LAN will
be passed through the WAN interface.
55