Load-Balance Policy - Draytek Vigor2820 Series User Manual

Add Tag
Click Clear to remove all the configurations in this page if you do not satisfy it. When you
finish the configuration, please click OK to save and exit this page. Or click Cancel to abort
the configuration and exit this page.
3 . 1 . 6 L o a d - B
3 . 1 . 6 L o a d - B
This router supports the function of load balancing. It can assign traffic with protocol type,
IP address for specific host, a subnet of hosts, and port range to be allocated in WAN1 or
WAN2 interface. The user can assign traffic category and force it to go to dedicate network
interface based on the following web page setup. Twenty policies of load-balance are
supported by this router.
Note: Load-Balance Policy is running only when both WAN1 and WAN2 are activated.
Index
Enable
Protocol
54
IGMP.
IGMP – It means that the PVC can accept packets of IGMP only.
To identify the usage of PVC, check this box to invoke this setting.
And type the number for VLAN ID (number).
a l a n c e P o l i c y
a l a n c e P o l i c y
Click the number of index to access into the load-balance policy
configuration web page.
Check this box to enable this policy.
Use the drop-down menu to change the protocol for the WAN
interface.
Vigor2820 Series User's Guide