Drainage - Miele G 7883 Operating Instructions Manual

^ The drainage system is fitted with a
non-return valve which prevents dirty
water from flowing back into the
machine via the drain hose.
^ The machine should preferably be
connected to a
system onsite.
If separate drainage is not available
contact your Miele application
specialist for advice.
The onsite drain connection point
should be located between 1 ft.
(0.3 m) and 3 ft. (1 m)
If it is lower than 1 ft. (0.3 m), lay the
hose in a curve at a height of at least
1 ft. (0.3 m).
The drainage system must be able to
take a minimum drainage flow of
16 l/min.
^ The drain hose is approx. 5 ft. (1.5 m)
long, is flexible and has an internal
7
diameter of /
8
not be shortened. Hose clamps are
supplied for securing it in position.
^ A longer drain hose (up to 12 ft. [4 m]
long) is available to order from the
Miele Technical Service Department.
^ The drainage system must not
exceed 12 ft. (4 meters).
^ See the supplied installation diagram.

drainage

.
in. (22 mm). It must
57