Setting The Dosage Concentration (Dos 3, Neutralizer); Priming The Neutralizer System (Dos 3, Neutralizer); If The System Is Primed Only - Miele G 7883 Operating Instructions Manual

Before performing any of the
following special functions, the
programming mode of the controller
needs to be accessed.
The dosage is factory set at 0.10, you
may or may not be required to adjust it.
Set the dosage concentration
according to the detergent
manufacturer's recommendations.
Example:
The manufacturer recommends a
neutralizer concentration of 0.3 %.
The value to be set is 0.30.
^ First access the programming level
E02.
^ Turn the program selector clockwise to
"Intensive". The display shows the set
dosage concentration
in % from 0.05 % - 0.5 %.
^ Press and hold "Display" ß until the
desired value appears.
^ Please note the dosage setting:
^ Press the "Start" 6 button. "SP"
appears in the display.
^ Press the "Start" 6 button again. The
setting has been saved.
NOTE: This change will set the
neutralizer dispensing amount for all
wash programs that use neutralizer.
^ Turn the program selector to
"Universal". "do3" appears in the
display.
^ Press "Display" ß.
The dosage system will be primed
automatically. The priming is complete
when "0" appears in the display.
^ Press the "Start" 6 button. "SP"
appears in the display.
^ Press the "Start" 6 button again. The
setting has been saved.
^ Select programming level 2
(see "Accessing the programming
level").
^ Turn the program selector to "Universal".
"do3" appears in the display.
^ Press "Display" ß.
The dosage system will be primed
automatically. The priming is
complete when "0" appears in the
display.
^ Turn the machine off with the "On/Off"
button.
^ Run the "Rinse" program afterwards to
remove any detergent or neutralizer
residues in the wash chamber.
37