Setting And Priming The Neutralizer; To Access The Programming Mode; To Store The Settings; Drying - Miele G 7883 Operating Instructions Manual

First you need to access the
programming mode:
^ Turn the program selector to "Stop"
f.
^ Turn the machine off.
^ Press and hold the "Display" ß and
"Start" 6 button.
turn the lab washer on by the main
switch .
The display shows the current
program status "P...".
The Fill/Drain indicator lights.
^ Press the "Drying" 0 button twice.
"E02" (programming level 2) appears
in the display.
20
The dosage is factory set to 0.10, you
may or may not be required to adjust it.
Set the dosage concentration
according to the detergent
manufacturer's recommendations.
Example:
The manufacturer recommends a
neutralizer concentration of 0.3 %. The
value to be set is 0.30.
^ First access the programming level to
"E02".
^ Turn the program selector clockwise to
"Intensive".
The display shows the set dosage
concentration in % from 0.05 % -
0.5 %.
^ Press and hold the "Display" ß
button until the desired value
appears.
The dosage time / dosage
concentration is saved.
^ Please note the dosage setting:
^ Press the "Start" 6 button. "SP"
appears in the display.
^ Press the "Start" 6 button again. The
change has been saved.
This change will set the
neutralizer dispensing amount for all
wash programs that use neutralizer.