Siemens Sinumerik 840C Diagnostics Manual page 53

04/96
01/99
3007 Error in programming setting data
Scan
When executing a part program
S
Effect
Machining stops
S
Explanation
M19 without S word
S
Spindle not present
S
Illegal setting data programmed,
e.g. G92 X... Y..., G92 D, T, A, I, J
S
Error in parameterization of handwheel pulse weighting for G27 (SD 564*)
S
Remedy
Check the faulty block in the "Correction block" display
S
If possible the cursor is positioned in front of the faulty word
S
The number of the faulty block is after the alarm number in the alarm line
Note
Alarm is displayed with reference to block and channel
3008 Subroutine error
Scan
When executing a part program
S
Effect
Machining stops
S
Explanation
M17 not in the subroutine
S
M02, M30 in the subroutine
S
M17 in the main program
S
More than 8 subroutine levels
S
Remedy
Check the faulty block in the "Correction block" display
S
If possible the cursor is positioned in front of the faulty word
S
The number of the faulty block is after the alarm number in the alarm line
S
SW 3 and higher, number of permissible subroutine levels exceeded
S
Subroutine call in the block with M2, M30 or M17
S
From SW 5 subroutines and main programs can be terminated with M02, M17 and M30.
Note
Alarm is displayed with reference to block and channel
3009 Program disabled
S
Scan
On NC START, or when editing a program during machining
S
Effect
Machining stops
S
Explanation
Pressing "NC START" calls a program which was disabled by being opened, by "Copy" or by "Rename". While
a program is being edited it may not be called by "NC START".
Remedy
Once editing is complete, the locked program must be enabled.
Note
Alarm is displayed with reference to block and channel
3010 Intersection error
S
Scan
When executing a part program
S
Effect
Machining stops
Explanation
A mistake has been discovered during reference processing in conjunction with the calculation of intersection.
Possible causes are:
S
Contour program without G00, G01, G03
S
Contour program with "Empty buffer memory" (@714)
S
Programmed axes are not the same as the plane selected
S
No intersection found
S
Stock removal path circular
S
R parameter number not available
Remedy
Check program in which contour is stored.
Note
Alarm is displayed with reference to block and channel

Siemens AG 2001 All rights reserved 6FC5198–jAB40
SINUMERIK 840C / SIMODRIVE 611–D (DA)
1 Alarms
1.5.1 Alarm description
Acknowledgement key
Acknowledgement key
Acknowledgement key
Acknowledgement key
1–45