Siemens Sinumerik 840C Diagnostics Manual page 190

1 Alarms
1.5.1 Alarm description
0x0633
0x0634
0x0635
0x0636
0x0637
0x0638
0x0639
0x0640
0x0641
0x0642
0x0643
0x0644
0x0645
0x0701 Function no.
0x0702 –
0x0703 Function no.
0x0704 Function no.
0x0705 Function no
0x0706 Function no.
Note
Applies as from SW 3.
1–182
Invalid init-task event
Error in drive configuration
Invalid drive type (gsi_anlaufart)
Invalid smtk_event
Illegal transmission parameter in
taster_übernahme()
Timeout during drive ramp-up – status 0 is
not acknowledged by the drive
Illegal transmission parameter in
meldung_servo_6xx()
Illegal status test formation of drive bus
(gsi_zust_businit)
Faulty length of boot block 1
Faulty length of boot block 2
Timeout during transmission of initial pro-
gram loader
Faulty transmission parameter for
fw_611D_urladen()
Faulty status
fw_611D_urladen()
Overflow with orders
(internal communication servo, drive)
Overflow with acknowledgements
(internal communication servo, drive)
Timeout
(internal communication servo, drive)
Handshake error
(internal communication servo, drive)
Unknown order
(internal communication servo, drive)
Unknown acknowledgement
(internal communication servo, drive)

Siemens AG 2001 All rights reserved 6FC5198–jAB40
Replace NC module
Reinstall NC system software
Delete drive configuration
Reinstall NC system software
Replace hardware:
control module 611D,
NC module
Replace hardware:
control module 611D,
NC module
Replace hardware:
control module 611D,
NC module
Replace 611D control module
Reinstall drive firmware
Replace hardware:
control module 611D,
NC module
Replace hardware:
control module 611D,
NC module
Reinstall drive firmware
check hard disk
replace NC module
Reinstall drive firmware
check hard disk
replace NC module
Replace hardware:
control module 611D,
NC module,
Contact service
Replace hardware,
reinstall NC system software
Contact service
Replace NC module
reinstall NC system software
Contact service
Contact service
Contact service
Only SW 4: Set identical axis-
specific position control cycle multi-
plication for all axes or resort the
axes so that they are sorted accord-
ing to descending position control
cycle (e.g. 1st axis 4 ms, 2nd axis
2 ms, 3rd axis 1 ms)
Otherwise: Increase cycle times for
drive to obtain more calculation time
for the communication.
Only SW 4: Set identical axis-
specific position control cycle multi-
plication for all axes or resort the
axes so that they are sorted accord-
ing to descending position control
cycle (e.g. 1st axis 4 ms, 2nd axis
2 ms, 3rd axis 1 ms)
Otherwise: Contact service
Contact service
Contact service
SINUMERIK 840C / SIMODRIVE 611–D (DA)
04/96