Siemens Sinumerik 840C Diagnostics Manual page 156

1 Alarms
1.5.1 Alarm description
160019 Invalid tacho adaptation
Scan
Parameterization/starting startup functions
Effect
The startup function cannot be started
Explanation
See machine data description
Remedy
Check/correct machine data for tacho adaptation
160020 A measuring function is already active
Scan
Starting startup functions
Effect
The startup function cannot be started
Explanation
Only one measuring function at a time can be active
Remedy
Stop previous measuring function and repeat procedure
160022 Illegal bus selection
Scan
When starting DAC output
Effect
DAC output cannot be started
Explanation
Startup application internal error; it is not possible to access 611D hardware
Remedy
End application and repeat procedure
160023 Illegal component
Scan
When starting DAC output
Effect
DAC output cannot be started
Explanation
Signal selection does not correspond to drive components
Remedy
Correct parameterization
160024 There is no signal
Scan
Starting DAC output
Effect
DAC output cannot be started
Explanation
The selected signal is not available
Remedy
Correct signal selection
160025 Protected data area selected (segment)
Scan
Starting DAC output from memory location
Effect
DAC output cannot be started
Explanation
Selected address area is not allowed
Remedy
Correct segment parameterization
160026 Protected data area selected (offset)
Scan
When starting DAC output from memory location
Effect
DAC output cannot be started
Explanation
Selected address area is not allowed
Remedy
Correct offset parameterization
160027 Illegal offset parameterized
Scan
When starting DAC output
Effect
DAC output cannot be started
Explanation
Offset value is outside the permissible range
Remedy
Correct offset value
1–148

Siemens AG 2001 All rights reserved 6FC5198–jAB40
SINUMERIK 840C / SIMODRIVE 611–D (DA)
04/96
OK softkey
OK softkey
OK softkey
OK softkey
OK softkey
OK softkey
OK softkey
OK softkey