Change Nas Server Name - Fujitsu ETERNUS DX60 S3 User Manual

Chapter 4 Connectivity Management
4.8 NAS Management
4.8.7

Change NAS Server Name

This function changes the server name (host name) for the ETERNUS DX S3 series that is used for the NAS
system.
This function is used in a Unified Storage environment.
• When performing Active Directory authentication, the ETERNUS DX S3 series' NAS engine uses the NAS
server name as the NetBIOS name. If the NAS server name is changed, the Active Directory
authentication server must be reconfigured.
• If the Active Directory authentication server has already been registered before changing the NAS server
name, perform the following operations.
(1) Delete the setup information for the Active Directory authentication server before starting this
function.
(2) Execute this function to change the NAS server name and then register the Active Directory
authentication server again.
Refer to "4.8.9 Set Authentication Server" (page 515)
Active Directory authentication server setup information.
• As a factory default NAS server name, "DXyyyyyyyyyy" ("DX" is fixed and "yyyyyyyyyy" indicates the serial
number of the ETERNUS DX S3 series) is specified for the ETERNUS DX S3 series.
• To revert back to the default NAS server name, clear the "Name" field and click the [Change] button.
For details on the parameters for this function, refer to
For the factory default settings for this function, refer to
The procedure to change the server name that is used for the NAS system is as follows:
Procedure
1
Click [Change NAS Server Name] in [Action].
512
ETERNUS Web GUI User's Guide (Settings)
Copyright 2015 FUJITSU LIMITED
for procedures on how to delete and re-register the
"A.4.7.5 Change NAS Server Name" (page
"Appendix B Change NAS Server Name" (page
894).
1002).
P2X0-1270-13ENZ0