Chapter 4 Connectivity Management
4.3 CA Port Group Management
■
Setting FC Port Parameters Manually
The procedure to set FC port parameters is as follows:
Procedure
1
Select which FC port to set the parameters for (multiple selections can be made) and click
[Configure FC Port] in [Action].
•
Multiple selections can be made from FC ports that have the same "Type" and "Port Mode".
•
Multiple ports can be set with the same or with different parameters in a single operation. To set
parameters to multiple ports, select the target ports and specify the parameters for each port.
After the specification is complete, click the [Modify] button.
2
Set the parameters for all of the selected ports.
The settings of port parameters vary depending on the port mode
442),
"When the port mode is "RA" or "CA/RA"" (page
443)).
■ When the port mode is "CA"
The main setting items are as follows.
●
Port Settings
•
Port
•
Connection
•
Set Loop ID
•
Loop ID
•
Transfer Rate
442
ETERNUS Web GUI User's Guide (Settings)
Copyright 2015 FUJITSU LIMITED
("When the port mode is "CA"" (page
443), or
"When the port mode is "Initiator"" (page
P2X0-1270-13ENZ0