Fujitsu ETERNUS DX60 S3 User Manual page 428

Chapter 4 Connectivity Management
4.2 Host Group Management
The main setting items are as follows.
●
SAS Host Setting
• Name
• SAS Address
• Host Response
• The range of LUNs that can be recognized from the host are determined by the "LUN Addressing"
settings and the "LUN Expand Mode (Peripheral Device Addressing)" settings for the host
response. Before changing a host response, check the LUN setting state. If LUNs that are LUN#256
onward are used, the recognizable LUN setting cannot be changed to a "256 LUN" host response.
Refer to
• If an error screen appears under the following conditions, check the parameter settings.
-
-
-
-
-
-
-
3
Click the [Modify] button
 A confirmation screen appears.
4
Click the [OK] button.
 Changing of the SAS host information starts.
5
Click the [Done] button to return to the [SAS Host] screen.
"Host responses and recognizable LUNs" (page 818)
The "Name" is not entered
The "Name" does not satisfy the input conditions
The "Name" already exists
The "SAS Address" is not entered
The "SAS Address" does not satisfy the input conditions
The same "SAS Address" is already registered in the ETERNUS DX
There are some LUNs that cannot be recognized from the SAS host because the "Host
Response" setting has been changed (only for SAS hosts that are not registered in a host
group)
ETERNUS Web GUI User's Guide (Settings)
Copyright 2015 FUJITSU LIMITED
428
for details.
End of procedure
P2X0-1270-13ENZ0