Freeze - Sony DPS-V55 Manual

2 Channel Effects
36 Freeze (Freez)
This effect records and plays back the
input sound. Use it as a simple
sampler.
Operating the Effect
Recording
This effect is automatically set to the
record standby mode when it is
selected (via an effect type or program
change operation) . Just activate the
trigger to start recording.
Playback
When recording has finished, the
previously output sound is cut and the
effect automatically switches to play
mode. To start playback, activate the
trigger.
Recording Again
To record again, simply reset the REC
Ready parameter to switch the unit to
record standby mode.
Notes
• The recorded sound is erased if you:
1 turn off the power, 2 select another
program (program change), 3 change
the effect type.
• The sound cannot be saved, even if you
save the effect.
Parameters
No. Name
– FxA(B) On/Off
1 Start Point
2 Stop Point
3 Loop Point
4 REC Ready
5 Trigger
6 Threshold
Range Comments
On, Off Turns the effect on or off.
–100 ~ 0 ~ 1200 Determines where playback will start.
–100 ~ 0 ~ 1200 Determines where playback will stop.
Determines the position of the playback loop. Setting different values for the Loop
–100 ~ 0 ~ 1200
Point and Stop Point allows you to play back the area in between repeatedly (loop
playback). If both points have the same value, playback stops automatically.
Off, On To record again after playback, set this parameter to "On" to set the effect to record
standby mode.
Signal, Tap Selects how the trigger will be activated.
Signal: activates the trigger when the signal level surpasses the Threshold.
Tap: activates the trigger when ENTER (TAP) is pressed.
0 ~ 100 When Trigger is set to "Signal", the trigger activates when signals larger than the value
set in this parameter are input.
39