Panasonic DBS-576 Technical Manual page 365

Section 400-Programming
Notes:
Introduction
Press the BLK-DOWN soft key instead of the last HOLD in the above address, to scroll to the next
BSSC trunk position and assign it a trunk number (stay in same address).
Before removing a Trunk Card from a Free Slot, you must first clear the Trunk Numbers (if assigned)
0
from all of the Card's BSSC ports in this address. See pg. 0-3 for more information.
System
Configuration
The range of trunk numbers available for assignment depends on the CPC used:
with a CPC-96:
with a CPC-288:
FF1
with a CPC-576:
System
Related Programming:
Trunk Numbering (pg. 1-22)
FF2
Trunks
Trunk Signal Type
FF3
(all CPCs) - Version 1.0 or higher
Extensions
Set the T1 channel's signaling type.
FF4
FF-/Soft Keys
BSSCC: T1 (E&M Tie) Channel Position
B=Cabinet no. 1-6
SS=Slot no. 01-12
FF5
CC=Channel no. 01-24
Groups
Notes:
FF6
TRS/ARS
Related Programming:
FF7
Applications
FF8
Maintenance
Appendix A
Appendix B
576-13-400
Trunk Nos. 1-96
Trunk Nos. 1-288
Trunk Nos. 1-576
FF1 0 02 0001 Hold (0 or 1) Hold
FF2 2 BSSCC
DBS 576 (USA) issued 05/20/98
FF2: Trunk Programming (T1 E&M Tie)
02 00 Hold (0-5) Hold
4=E&M/AC15 (Immediate Start)
5=E&M/AC15 (Wink Start) (default)
NOTE: Settings 0-3 apply to T1 Trunks (CO).
See pg.
2-86
$
, %6
for more information.
Page 2-117
Introduction
0
System
Configuration
FF1
System
FF2
Trunks
FF3
Extensions
FF4
FF-/Soft Keys
FF5
Groups
FF6
TRS/ARS
FF7
Applications
FF8
Maintenance
Appendix A
Appendix B