Initializing A New Phone System; Cpc Reset ("Ramclear) - Panasonic DBS-576 Technical Manual

Introduction to DBS 576 Programming
Introduction

Initializing a New Phone System

CPC Reset ("RAMCLEAR")
0
System
Configuration
After installing a phone system for the first time, the CPC (Central Processing Card)
should be reset to default values before programming the system.
FF1
System
FF2
The switches, buttons and LEDs in the following
Trunks
steps are located on the CPC card.
1. Set the CODE rotary switch to 2.
FF3
2. Set the RAM HOLD switch to OFF.
Extensions
3. Press and hold in the MODE button, then
FF4
FF-/Soft Keys
FF5
4. Move the RAM HOLD switch to ON.
Groups
FF6
TRS/ARS
5. At any installed display phone, press ON/
FF7
Applications
6. Perform Initial Settings for the system,
FF8
Maintenance
Appendix A
Appendix B
Intro-4
IMPORTANT: This procedure must be performed before you program
the system; otherwise, the system will not work.
press the RESET button or power-on the
system.
•
Wait for the MJ (Major) and MN (Minor)
LEDs to come on before releasing the
MODE button.
•
Wait for the MJ and MN LEDs to
extinguish, and the RUN LEDs to blink
continuously.
•
All display phones should now show
"Welcome to DBS" on the top line.
OFF. This will bring up Programming Mode,
and display the software version number.
either manually via Programming Mode
(see next page) or by choosing a set of
preprogrammed initial settings (see pg.
Intro-6).
DBS 576 (USA) issued 05/20/98
Section 400-Programming
The CPC-576 Card
(front edge, facing out from cabinet)
RUN LED (FPU)
RUN LED (MPU)
MJ LED
MN LED
RESET button
CODE rotary switch
MODE button
RAM HOLD switch
MOH plug-in
576-13-400
Introduction
0
System
Configuration
FF1
System
FF2
Trunks
FF3
Extensions
FF4
FF-/Soft Keys
FF5
Groups
FF6
TRS/ARS
FF7
Applications
FF8
Maintenance
Appendix A
Appendix B