Panasonic DBS-576 Technical Manual page 225

Section 400-Programming
Introduction
FF1 3: MCO Access in Tenant Groups
NOTE: Tenant Groups provide a way to divide the phone system into different
0
System
Configuration
FF1
System
FF2
Trunks
FF3
Extensions
FF4
FF-/Soft Keys
FF5
Groups
FF6
TRS/ARS
FF7
Applications
FF8
Maintenance
Appendix A
Appendix B
576-13-400
departments, or even different companies sharing the same phone system, for
inbound and outbound calls.
Available range of MCO Tenant Groups depends on the CPC card used:
up to 12 Tenant Groups with a CPC-96
up to 36 Tenant Groups with a CPC-288
up to 72 Tenant Groups with a CPC-576.
Individual trunks are assigned to Tenant Groups in FF2.
Individual extensions are assigned to Tenant Groups in FF3.
Trunks are assigned to Outbound Trunk Groups in FF5 - 2.
Outbound Trunk Groups are assigned to Tenant Groups in:
Tenant Group MCO Access: Outbound Trunk Groups (see below)
FF1 3 01 (0001-0360) Hold (0-99 or 0-72) Hold
Extension COS: Direct Trunk Access (pg. 1-46)
FF1 0 03 (00-15) 13 Hold (0 or 1) Hold
0=allow 1=do not allow
TRS Level for Path (non-ARS) (pg. 6-16)
FF6 1 00 (01-50) Hold (0001-0099) Hold (0-9) Hold
(01-50): TRS Class No. of originating extension.
(0001-0099): Trunk Group No. of seized trunk
(0-9): TRS Levels: 0=restrict all calls ... 9=allow all calls
Route Table: Trunk Group Assignment (pg. 6-36)
FF6 2 04 (001-200) 0001 Hold (0-99) Hold
(001-200): Route No.
(0-99): Trunk Group No.
DBS 576 (USA) issued 05/20/98
FF1: System Programming
default: 0 (no assignment)
default: Tenant Group 1
default: (no assignment)
defaults:
Tenant 1/MCO-1=TG#1
Tenant 2/MCO-1=TG#2
Tenant 3/MCO-1=TG#3
etc.
default: 0 (allow)
default: 9 (allow all calls)
default: 0 (no assignment)
Page 1-163
Introduction
0
System
Configuration
FF1
System
FF2
Trunks
FF3
Extensions
FF4
FF-/Soft Keys
FF5
Groups
FF6
TRS/ARS
FF7
Applications
FF8
Maintenance
Appendix A
Appendix B