Hitachi GR2000 Series Configuration Commands page 403
Hitachi gigabit router configuration guide
Hide thumbs
Also See for GR2000 Series:
- Installation manual (18 pages) ,
- Installation manual (410 pages)
Table of Contents
Advertisement
Table 5-3
The total of traffic cbr pcr, vbr scr, and abr mcr
exceeded vp pcr.
The total of traffic gfr mcr exceeded vp pcr.
The total of traffic gfr2 mcr exceeded vp pcr.
Timeslot number not specified.
Traffic not specified.
Tunnel interface is not defined.
Can not change tunnel type.
6to4 tunnel is already defined.
Type not specified.
Vpi not specified.
width is not in range of 1 to 2.
width is not in range of 1 to 24 or not 48, 72,
96.
width is not in range of 1 to 24.
width is not in range of 1 to 31.
Width not specified.
<item> is not in range <value1> to <value2>.
<Option> out of range.
GR2K-GA-0014
Ver. 07-02
Network Interface Error Messages (continued)
The total of traffic cbr pcr, vbr scr, and abr mcr exceeded vp pcr. Set
the total traffic to VP's PCR or less.
The total of traffic gfr mcr exceeded vp pcr. Set the total traffic to
VP's PCR or less.
The total of traffic gfr2 mcr exceeded vp pcr. Set the correct value.
Timeslot number has not been specified. Specify a timeslot number.
Traffic has not been specified. Specify traffic.
Tunnel interface is not defined. The 256th interface cannot be set
when a tunnel interface is defined. Reconfirm the number of IP
interfaces.
It is not possible to change configured tunnels to 6to4 tunnels and
vice versa.
Set new definitions after deleting tunnel interface information.
6to4 tunnel is already defined.
1 6to4 tunnel can be defined per device.
Traffic type has not been specified. Specify traffic type.
Vpi has not been specified. Specify vpi.
Timeslot width is not in range. Set timeslot width in range of 1 to 2.
Timeslot width is not in range. Set timeslot width in range of 1 to 24
or 48, 72, 96.
Timeslot width is not in range. Set timeslot width in range of 1 to 24.
Timeslot width is not in range. Set timeslot width in range of 1 to 31.
Timeslot width has not been specified. Specify a timeslot width.
<item> is not in range. Set <item> in range.
<item> Parameter name, <value1>Minimum value <value2>
Maximum value
<Option> is out of range. Check <option>.
Configuration Error Messages
5-13
Advertisement
Table of Contents
