Hitachi GR2000 Series Configuration Commands page 330

Hitachi Gigabit Router GR2000 Series Enhanced Version Configuration Commands, Vol. 2
Show the registration status of RMON event-group entry:
Delete registered RMON Ethernet event-group entry with the event-group index
number 3, and show the resulting event-group entries:
Related Configuration Objects
Related Information
The MIB value of an RMON Ethernet history group can be referenced using an SNMP
manager or this router's snmp command. For the snmp command, refer to GR2000
Operations Commands, Vol. 1.
Precautions
1. In order to access the Ethernet event-group information from an SNMP Manager
or issue a trap to an SNMP Manager, you must register the SNMP Manager. For
the latter purpose, specify -trap or -ex_trap option in the registration action.
2. Make sure that the rising_event_index and falling_event_index settings are equal to
those defined by the
executed in response to an alarm.
3. Make sure that the
object. If any discrepancy exists, no trap is transmitted in the specified event.
4. When RMON eventTable is sent from an SNMP Manager, the change is not
reflected in the router's configuration.
5. If this command is inputted in the cases where changes are made on the IP
routing protocol information, the IP multicast protocol information, and the
MPLS information, and the apply command is not being executed, the apply
subcommand is executed before the command is executed, and the changed IP
routing protocol information, IP multicast routing protocol information, and
MPLS information are reflected to the operation.
3-22
object. If any discrepancy exists, the event is not
alarm
setting is equal to the one defined by the
community snmp
GR2K-GA-0014
Ver. 07-02