Qos-Ip (Information On Ip Qos Of The Old Bsd Unix-Based Command System) - Hitachi GR2000 Series Configuration Commands

Related Commands
Related Information
For the flow control, refer to the GR2000 Applications Guide.
Precautions
1. Multiple IP frame condition groups cannot be set as inbound/outbound in a
single interface.
2. When exp is specified as a flow detection condition parameter by qos-ip-list , only
"in" specification is valid on the entry. "out" specification is invalid in this case.
The entry is valid only on the core router in an MPLS network. It is invalid on the
entrance and exit edge routers in an MPLS network.
3. Only the interface specification in RP after RP-C or RP-D is valid for the IP QoS
information when exp is specified as a flow detection condition parameter by
qos-ip-list or when replace-exp is specified as a flow control parameter. The
interface specification in RP other than described above is invalid.
4. If this command is inputted in the cases where changes are made on the IP
routing protocol information, the IP multicast protocol information, and the
MPLS information, and the apply command is not being executed, the apply
subcommand is executed before the command is executed, and the changed IP
routing protocol information, IP multicast routing protocol information, and
MPLS information are reflected to the operation.
1.2.8 qos-ip (Information on IP QoS of the Old BSD UNIX-based Command
System)
Establishes the IP QoS settings. The Qos IP frame condition group is determined
against the interface defined in the IP or IP-address settings. When IP QoS settings
are established, QoS is determined against the receipt packet or transmission packet
in an applicable interface. A maximum of 512 entries can be generated per device
(maximum interface 256, inbound/outbound for one interface).
Input Format
Settings
Change settings
Delete settings
GR2K-GA-0014
Ver. 07-02
Filtering/QoS Information
1-201