AMAX panel
Installation
1.
2.
3.
4.
For information on the installation, refer to Module Installation, page 26.
4.8.2
Address Setting
Set bus address to 134.
4.8.3
Wiring
The following graphics show how to wire ITS-DX4020-G to the option bus of the AMAX panel.
Two modes are possible: GPRS and GSM
AMAX 2100 / 3000
AMAX 3000 BE / 4000
Figure 4.11: GPRS mode in support of IP
Figure 4.12: GSM mode in support of PSTN (Contact ID)
4.8.4
Status Indicator
Normally, the AMAX panel tests the communication with the module. In case of a
communication failure, a fault report including the module address is sent.
The following table describes the status LED indicator of DX4020-G.
Bosch Sicherheitssysteme GmbH
All manuals and user guides at all-guides.com
Disconnect all power supplies of the AMAX panel before installing ITS-DX4020-G.
Insert SIM card.
Use the standard three-hole installation mode to install the ITS-DX4020-G in the
enclosure of the AMAX panel or another enclosure.
Connect the magnetic antenna to ITS-DX4020-G.
1RING
1RING
TIP
TIP
TIP
TH
RH
RING
Installation Manual
Optional Modules and Peripheral Devices | en
DX4020G
2015.05 | 06 | F.01U.309.277
23
DX4020G