Automatic Time Adjustment - Panasonic KX-NS700 Feature Manual

2.1.7 Automatic Time Adjustment

PS
ICD Group
SIP Extension
PS Ring Group
UM Group
VM Group (DTMF/DPT)
External Pager (TAFAS)
DISA
Analog/ISDN Remote Maintenance
Idle Line Access no. + Phone no.
Trunk Group Access no. + Trunk Group no. + Phone no.
Extension of Another PBX (via TIE Line, Access with PBX Code)
Extension of Another PBX (via TIE Line, Access without PBX Code)
A PS destination can be used to forward fax calls to a fax machine at another PBX connected by TIE line.
*1
A virtual PS can be specified as the destination of fax calls. Then, the extension number of the fax machine at the other PBX can
be specified as the FWD—ALL Calls destination for calls to that virtual PS. (→ 21.1.2 Virtual PS)
Conditions
•
This feature is only effective for calls arriving on DISA lines.
•
If a fax signal is not detected before the DISA Intercept Routing—No Dial timer expires, the call is
redirected to the operator extension, and fax detection ends.
•
If the fax tone (CNG signal) detection is delayed because of the fax machine type or the state of the line,
the DISA intercept timer may time out and the fax cannot be received. In this case, increasing the DISA
intercept timer by 5 to 10 seconds will help avoid this problem.
PC Programming Manual References
10.3 PBX Configuration—[2-3] System—Timers & Counters—DISA / Door / Reminder / U. Conf—DISA—
Intercept Timer—Day (s), Lunch (s), Break (s), Night (s)
13.3.2 PBX Configuration—[5-3-2] Optional Device—Voice Message—DISA Message—Fax Extension
Feature Manual References
5.1.10 DISA (Direct Inward System Access)
2.1.7 Automatic Time Adjustment
Description
The PBX clock can be adjusted automatically in the following two ways:
1.
Daylight Saving Time Setting
The start and end dates of Daylight Saving Time can be programmed. The PBX clock will automatically
adjust itself one hour forward or backward at 2:00 A.M. on the programmed date, if enabled through
system programming. At 2:00 A.M. on the start date, the clock will change to 3:00 A.M., and at 2:00
A.M. on the end date, the clock will change to 1:00 A.M.
32 Feature Manual
Destination Availability
ü
*1
ü
Document Version 2017-06