Advertisement
7. Press a square to choose a beam position.
N N o o t t e e
All nine beam positions have to be aligned individually.
8. Observe the beam for flickering through the view-
port. A flickering might be seen as two spots alter-
nating close to each other.
9. Press the arrows (Up-Down / Left-Right) until the
flickering stops and the two spots coincide as one.
10. Perform this procedure for all the nine beam
positions.
11. Press S S t t o o p p to deactivate the beam.
12. Press S S a a v v e e to save the alignment.
02
OM-710430
en-GB
129
Advertisement
