Network; Network Services; Network Access - Bosch AUTODOME 7100i User Manual

54 en | Configuration
–
–
–
–
–
Select the required output commands for both Output 1 and Output 2 settings from the
dropdown list:
Note: Not all options are available for all cameras.
–
–
–
–
–
–
Click the checkbox Enabled to activate the alarm.
Click Set to save. The camera's system activates the alarm rules.
4.7

Network

4.7.1

Network Services

This page shows an overview of all available network services.
Use the checkbox to activate or deactivate a network service.
Click the settings symbol next to the network services to go to the respective settings page.
4.7.2

Network Access

The settings on this page are used to integrate the VideoJet XF E into an existing network.
IP V4 address
Automatic assignment (DHCP)
If the network has a DHCP server for the dynamic assignment of IP addresses, select On to
automatically accept the DHCP-assigned IP address.
For certain applications, the DHCP server must support the fixed assignment between IP
address and MAC address, and must be appropriately set up so that, once an IP address is
assigned, it is retained each time the system is rebooted.
IP address
Enter the desired IP address for the camera. The IP address must be valid for the network.
Subnet mask
Enter the appropriate subnet mask for the selected IP address here.
Gateway address
If you want the unit to establish a connection to a remote location in a different subnet, enter
the IP address of the gateway here. Otherwise leave the box blank (0.0.0.0).
IP V6 address
IP address
Enter the desired IP address for the camera in this field. The IP address must be valid for the
network. A typical IPv6 address may resemble the following example:
2022-12 | V01 | DOC
Alarm input: Select the required alarm input in the second Input dropdown list to the
right.
Video analytics/MOTION+: Triggers and alarm when IVA or motion detection is activated.
Connection: Triggers an alarm will when an attempt is made to access the device's IP
address.
Time: Enter the time for the activation of the alarm in hours and minutes in the input
field.
Time range: Enter the time range for the activation of the alarm in hours and minutes in
the input fields.
None: No defined command.
Alarm output: Defines an alarm output.
AUX on: Defines a standard or custom keyboard ON command.
AUX off: Defines a standard or custom keyboard OFF command.
Pre-position: Defines a pre-position from shot 1-256.
(Note: This option is not available for the input Time range.)
Monochrome: Triggers the camera to give the output in monochrome mode.
User Manual
AUTODOME 7100i
Bosch Security Systems B.V.