Image Posting; Sd Card Status - Bosch AUTODOME 7100i User Manual

AUTODOME 7100i
Averaging period
Identifies how often (in seconds, minutes, hours, days or weeks) the encoder time is
synchronized to the actual time.
4.5.7

Image Posting

You can save individual JPEG images on an FTP server at specific intervals. You can then
retrieve these images at a later date to reconstruct alarm events if required. In order to
configure image posting, and to save and retrieve JPEG images, you must create an Account in
which to save and access them. If you have not configured an account, the following error
message appears at the top of this page: "No configured account. Configure accounts." Click
the link to access the Accounts page.
JPEG
Image size
Select the resolution you wish the JPEG images to have:
–
–
File name
Select how file names are created for the individual images that are transmitted.
–
–
–
VCA overlays
If you have enabled the display of VCA overlays on the Appearance page, select the VCA
overlays check box to have the overlays also visible in the JPEG image.
Posting interval
Enter the interval in seconds at which the images will be sent to an FTP server. Enter 0 (zero)
if you do not want any images to be sent.
Target
Select the target account for JPEG posting.
Notice!
The creation of JPEG images has a lower priority than video encoding and image analysis.
i
This can result in JPEG images being created with a delay of up to several seconds after the
triggering event. If reliable, real-time recording of the alarm is required, ensure that the
encoder has enough computing power available.
Notice!
i
You must configure an account in order to have functionality for Image Posting. Click on
Configure accounts to do so.
4.5.8

SD Card Status

It is recommended to use an industrial SD card with health monitoring and enhanced
performance. For non-industrial SD cards, the lifespan options are not available.
Bosch Security Systems B.V.
Medium 352 × 288/240 pixels (CIF)
Large 704 × 576/480 pixels (4CIF)
Overwrite: The same file name is always used and any existing file will be overwritten by
the current file.
Increment: A number from 000 to 255 is added to the file name and automatically
incremented by 1. When it reaches 255, it starts again from 000.
Date/time suffix: The date and time are automatically added to the file name. When
setting this parameter, make sure that the date and time of the device are always set
correctly. For example, the file snap011005_114530.jpg was stored on October 1, 2005 at
11:45 and 30 seconds.
User Manual
Configuration | en 47
2022-12 | V01 | DOC