Table of Contents
Advertisement
*** adjust this parameter until meter reads 566 VDC for a 460 volt drive or 283 VDC for a 230 volt drive
(from chart on page 2). Hit ENTER when adjusted.
Example of on-the-fly calibration of the AM terminal for output voltage
Adjust jumper 4 for 0-1 or 4-20 mA output
Connect meter to 'AM' and 'CC'.
Run the drive at some high frequency, say 60 Hertz.
Programming
UTILITY PARAMETERS
UTILITY PARAMETERS
AM/FM TERMINAL ADJUSTMENT PARAMETERS
AM/FM TERMINAL ADJUSTMENT PARAMETERS
**** use the up/down arrows to make meter read the same value as the drive is displaying here. Hit ENTER when adjusted.
For additional assistance, please contact Toshiba Adjustable Speed Drive Marketing Dept. at (800) 872-
Group
Parameter
Blind Function Selection
AM/FM Adjustment Parameters Unblind
AM Terminal Function Selection
Frequency Meter Adjustment
2192
New Value
1
1
5
****
43
Advertisement
Table of Contents
