Toshiba G3 Workbook page 18

*2 – Frequency Mode Selection controls how the frequency command is given to the drive. The
following settings are useable with 3 wire control .
0 – RS232 input valid. The frequency command is received via the RS232 port on the
control board
1 – Terminal Input Valid. The frequency command is received via the terminal strip E.G. a
manual pot.
2 – Panel Input, frequency command is received via the Up/Down arrows on the keypad.
3 – RS485 option board, frequency command is received via a communications option
board.
4 – Local/Remote control. Local/Remote light must be off.
The following programming makes STOP active upon opening S2-CC. This programming should only be
performed if a normally closed momentary switch is to be used for STOP.
PRG
LOCAL/REMOTE
READ/WRITE
READ/WRITE hold down
LOCAL/REMOTE
down arrow until
READ/WRITE
up arrow until
READ/WRITE
up arrow until
READ/WRITE
PRG
Cycle power when finished with programming
For additional assistance, please contact Toshiba Adjustable Speed Drive Marketing Dept. at (800) 872-
KEYSTROKE RESULTING DISPLAY
OUTPUT FREQUENCY
0.0 Hz
OUTPUT FREQUENCY
0.0 Hz
OUTPUT FREQUENCY
0.0 Hz
OUTPUT FREQUENCY
0.0 Hz
RAMF
EEP
0380
046A
0
8
046A alternating with 8, then 046A
OUTPUT FREQUENCY
0.0 Hz
2192
18