Adjustable Remote Torque Limit - Toshiba G3 Workbook

Introduction
The following programming steps enable on-the-fly remote torque limit on the G3. This limit is
adjusted via a speed pot connected to the 'RR' terminal. If you want to use another speed pot for a
speed reference, connect its wiper to 'RX' and do the required programming (not listed here). After
this programming is completed, a new group, GROUP:SUPERUSER, will be visible. Cycle drive
power after programming.
Connections
ST
Programming
Group
UTILITY PARAMETERS
UTILITY PARAMETERS
UTILITY PARAMETERS
UTILITY PARAMETERS
FUNDAMENTAL PARAMETERS #1
FEEDBACK PARAMETERS
FEEDBACK PARAMETERS
PROTECTION PARAMETERS
TERMINAL SELECTION PARAMETERS
See Guideline 18, True Torque Control for motor tuning information (necessary for torque
regulation).
For additional assistance, please contact Toshiba Adjustable Speed Drive Marketing Dept. at (800) 872-

Adjustable Remote Torque Limit

TERMINAL STRIP
CC
Blind Function Selection
Feedback Control Parameters Blind
Protection Function Parameters Blind
Terminal Selection Parameters Blind
Volts per Hertz Pattern
Drooping Control Enable
Drooping Control Amount
Stall Protection Enable
RR Input Special Function Select
PP RR
Parameter
2192
CC
Value
1
1
1
1
5
1
5
1
4
12
26