Spare Parts; Decommissioning; Disassembly And Replacement; Preparing The Product For Storage/Later Use - Bosch Rexroth HQ 5/H Assembly Instructions Manual

10.4.7 Spare parts

For a list of spare parts, see MTparts, 3 842 529 770.

11 Decommissioning

This product does not need to be decommissioned. Accordingly, this section has
been left blank.

12 Disassembly and replacement

High electrical voltage!
Risk of serious injury or death from electric shock.

Disconnect the relevant system component before performing maintenance or
servicing.

Secure the system against being unintentionally switched on again.
High pneumatic pressure!
Risk of serious injury or death.

Switch off the compressed air supply to the relevant system component before
performing any maintenance or repair work.

Secure the system against being unintentionally switched on again.
Suspended loads can fall!
Falling objects can result in serious injury (or even death).

Only use slings with a suffi ciently high bearing load (see delivery documents for
the product weight).

Make sure the lifting straps are correctly fastened before lifting the product.

Secure the product against tipping when lifting.

Make sure that no one but the operator is in the danger zone during lifting and
lowering.

12.1 Preparing the product for storage/later use

• Only set the product down on a fl at surface.
• Protect the product from mechanical infl uences.
• Protect the product from environmental infl uences, such as dirt and moisture.
• Observe the ambient conditions, see page 53.
• For products with a mounted motor: Support the product so that the motor is not
placed under mechanical load.
WARNING
3 842 558 544/2017-07, MIT: HQ 5/H, HQ 5/XH, Bosch Rexroth AG
Decommissioning 51/60