Symbols Used - Bosch Rexroth HQ 5/H Assembly Instructions Manual

Table 6: Symbols used
1 2
SW13
M = 20Nm
D
SW5
M = 8Nm
D
PZ2 PH3
gleitmo 585 K
1 2 3
A B C X

7.4 Symbols used

Connection with T-bolt and fl ange nut.
Make sure the T-bolt is in the correct position when inserting into the slot and
tightening. The notch at the head of the bolt indicates the orientation of the T-bolt.
1 = T-bolt insertion position in the slot
2 = T-bolt clamping position in the slot
Tightening torque: 25 Nm
Hex wrench
SW = wrench size ... mm
M = required tightening torque ... Nm
D
Hex socket wrench
SW = wrench size ... mm
M = required tightening torque ... Nm
D
Screwdrivers for cross-head screws
PZ ... = Pozidriv cross recess, size ...
PH ... = Phillips cross recess, size ...
Lubricate with specifi c grease lubricant:
• Fuchs Lubritech gleitmo 585 K: www.fuchs-lubritech.com
The marked parts are not required for the described assembly. Dispose of the
parts or use them for other purposes.
Graphical depiction of the installation steps.
The numbers correspond to the sequence of installation steps, in accordance with
the instructions in the accompanying text.
Graphical depiction of the designation of components.
The letters denote the components mentioned in the accompanying text.
Detail view from a different direction, for example, the back or the bottom side of
the product.
3 842 558 544/2017-07, MIT: HQ 5/H, HQ 5/XH, Bosch Rexroth AG
Assembly 17/60