Huawei USG6000E Series Hardware Manual page 578

HUAWEI USG6000E Series
Hardware Guide
Step 2 Pull the ejector lever on the hard disk holder, keep it in pulled-out state, and push
the hard disk holder with two hands along the guide rails of the slot till the front
surface of the hard disk holder touches the USG panel.
Figure 5-47 Installing a hard disk
Step 3 After the ejector lever of the hard disk is fastened to the chassis, close the hard
disk ejector lever.
Step 4 After the installation is complete, perform the following operations:
●
●
----End
5.5.4 Connecting a Console Cable
After connecting a PC to the console port of a USG6680E, USG6712E, USG6716E
with a console cable, you can use the terminal emulation program on the PC to
access the command configuration interface of the USG6680E, USG6712E,
USG6716E.
Issue 08 (2022-04-20)
NO TE
Operations after the USG power-on must be performed after all installation tasks are
complete.
Before the USG is powered on, ensure that the hard disk is correctly installed.
After the USG is powered on, run the display disk information command in
the user view to check whether the Filesystem Status value is Mounted.
Copyright © Huawei Technologies Co., Ltd.
5 Hardware Installation
571