HUAWEI USG6000E Series
Hardware Guide
●
5.5.3 Installing a Hard Disk
This section describes how to install a hard disk units for the first time to avoid
hard disk damage.
Precautions
Precautions for the use of hard disks
●
●
●
●
Tool
ESD bag
Procedure
Step 1 Remove the filler panel from a hard disk slot.
Figure 5-46 Removing the filler panel from a hard disk slot
Issue 08 (2022-04-20)
The electrical resistance between the ground terminal and ground point is less
than 0.1 ohm on a multimeter.
Use Huawei hard disks. The system cannot recognize the hard disks provided
by other vendors.
Wear an ESD wrist strap to protect the USG and hard disks from electrostatic
damage.
Hold the two side surfaces of a hard disk, do not touch the PCB board or
squeeze the hard disk, and do not vibrate, bump, or stack hard disks.
For mapping relationships between the USG and hard disks, see
Overview.
Copyright © Huawei Technologies Co., Ltd.
5 Hardware Installation
Hardware
570