Huawei USG6000E Series Hardware Manual page 530

HUAWEI USG6000E Series
Hardware Guide
●
●
●
Tools
●
●
Procedure
Step 1 Determine the slot (the slot with a "micro SD" mark on the rear panel) for
installing the micro SD card.
Step 2 Install the micro SD card and anti-theft board.
1.
2.
3.
Issue 08 (2022-04-20)
SD card model is SDSDQAE-064G, the capacity is 64 GB, and dimensions (H x
W x D) are 1 mm x 15 mm x 11 mm (0.04 in. x 0.59 in. x 0.43 in.).
The micro SD card can be installed no matter the device is powered off or the
device is running. The installation methods are the same. In this section, the
micro SD card is installed when the device is powered off.
To replace the micro SD card when the USG is powered on, you must run the
sd-card offline command in the system view first. After the system displays a
message indicating that the micro SD card is offline, remove the micro SD
card. Otherwise, the micro SD card might be damaged, and the data may be
lost. For details, see
POE, USG6530E).
Make sure that you have worn an ESD wrist strap and the strap is well
grounded before you hold the micro SD card. Otherwise, the micro SD card
may be damaged.
Phillips screwdriver
ESD wrist strap
NO TE
● Note that the micro SD card must be installed with the face with words upwards.
● Do not use too much force; otherwise the micro SD or micro SD card slot might be
damaged.
Insert the micro SD along the guide rail to the micro SD card slot.
When you hear a click, the micro SD card is in position.
Hook the locating hook on the anti-theft board to the locating hole of the
rear panel and tighten the captive screw on the anti-theft board.
Copyright © Huawei Technologies Co., Ltd.
Replacing a Micro SD Card (USG6510E, USG6510E-
5 Hardware Installation
523