Table of Contents
Advertisement
DGS-3130 Series Layer 3 Stackable Managed Switch Web UI Reference Guide
The fields that can be configured are described below:
Parameter
Unit
From Port - To Port
Instance
Receiver
Mode
Sampling Rate
Max Header Size
Click the Apply button to accept the changes made.
Click the Delete button to remove the specified entry.
Enter a page number and click the Go button to navigate to a specific page when multiple pages exist.
sFlow Poller Settings
This window is used to display and configure the sFlow poller settings.
To view the following window, click Monitoring > sFlow > sFlow Poller Settings, as shown below:
Figure 11-109 sFlow Sampler Settings Window
Description
Select the Switch unit that will be used for this configuration here.
Select the appropriate port range used for the configuration here.
Enter the instance index number if multiple samplers are associated with one
interface. The valid range is from 1 to 65535.
Enter the receiver index for this sampler. If not specified, the value is 0. This
value must be between 1 and 4.
Select the mode here. Options to choose from are Inbound and Outbound.
• Selecting Inbound specifies to sample ingress packets. This is the default
direction of a sampler.
• Selecting Outbound specifies to sample egress packets.
Enter packet sampling rate here. This value must be between 0 and 65536.
Entering 0 will disable this function. If not specified, the default value is 0.
Enter the maximum number of bytes that should be copied from sampled
packets. This value must be between 18 and 256 bytes. By default, this value is
128 bytes.
Figure 11-20 sFlow Poller Settings Window
418
Advertisement
Table of Contents
