Table of Contents
Advertisement
DGS-3130 Series Layer 3 Stackable Managed Switch Web UI Reference Guide
Parameter
PD Alive State
PD IP Address
Poll Interval
Retry Count
Waiting Time
Action
Click the Apply button to accept the changes made.
PoE Statistics
This window is used to display and clear the PoE statistics on the Switch ports.
To view the following window, click System > PoE > PoE Statistics, as shown below:
The fields that can be configured for PoE Statistics Table are described below:
Parameter
Unit
Click the Clear All button to clear PoE statistics for all ports.
Click the Clear button to clear the PoE statistics for the corresponding port.
Description
Select to enable or disable the state of the PoE alive function on the specified
port(s) here.
Enter the IPv4 address of the target PD here.
Enter the poll interval value here. The range is from 10 to 300 seconds. This is
the interval at which ping requests will be sent to the target PD to check the
status.
Enter the retry count value here. The range is from 0 to 5. This is the amount of
times that the ping request will be resend if the target PD does not respond.
Enter the waiting time value here. The range is from 30 to 300 seconds. This is
the time the Switch will wait for the PD to recover from rebooting.
Select the action that will be taken here. Options to choose from are:
• Reset - Specifies to reset the PoE port state.
• Notify - Specifies to send logs and traps to notify the administrator.
• Both - Specifies to send logs and traps and then to reset the PoE port
state.
Figure 3-156 PoE Statistics Window
Description
Select the stacking unit ID of the Switch that will be used here.
19
Advertisement
Table of Contents
