Table of Contents
Advertisement
DGS-3130 Series Layer 3 Stackable Managed Switch Web UI Reference Guide
Click the Delete button to delete the specified entry.
After selecting the Neighbor Discover tab option, at the top of the page, the following page will be available.
After selecting the DHCPv6 Client tab option, at the top of the page, the following page will be available.
Click the Restart button to restart the DHCPv6 client service.
The fields that can be configured for DHCPv6 Client Settings are described below:
Parameter
Client State
Click the Apply button to accept the changes made.
Loopback Interface
This window is used to display and configure the loopback interface settings. A loopback interface is a software only
interface which always stays in the up status.
To view the following window, click L3 Features > Interface > Loopback Interface, as shown below:
Figure 6-43 IPv6 Interface (Detail, Interface IPv6 Address) Window
Figure 6-54 IPv6 Interface (Detail, Neighbor Discover) Window
Figure 6-65 IPv6 Interface (Detail, DHCPv6 Client) Window
Description
Select to enable or disable the DHCPv6 client service here. Select the Rapid
Commit option to proceed with two-message exchange for address delegation.
The rapid-commit option will be included in the Solicit message to request a
two-message handshake.
192
Advertisement
Table of Contents
