Table of Contents
Advertisement
DGS-3130 Series Layer 3 Stackable Managed Switch Web UI Reference Guide
Parameter
Destination
Time Range
Click the Apply button to accept the changes made.
Click the Back button to discard the changes made and return to the previous page.
Extended IP ACL
After selecting an Extended IP ACL and clicking the Add Rule button, the following page will appear.
The fields that can be configured are described below:
Parameter
Sequence No.
Action
Protocol Type
Description
Select and enter the destination information here. Options to choose from are
Any, Host, IP, and Wildcard.
• When the Any option is selected, any destination traffic will be evaluated
according to the conditions of this rule.
• When the Host option is selected, enter the destination host IP address
here.
• When the IP option is selected, the Wildcard option will also be available.
Enter the group of destination IP addresses by using a wildcard bitmap.
The bit corresponding to the bit value 1 will be ignored. The bit
corresponding to the bit value 0 will be checked.
Enter the name of the time range profile that will be used in this ACL rule here.
This name can be up to 32 characters long.
Figure 8-12 Extended IP ACL (Add Rule) Window
Description
Enter the sequence number of this ACL rule here. The range is from 1 to
65535. If this value is not specified, the system will automatically generate an
ACL rule number for this entry.
Select the action that this rule will take here. Options to choose from are
Permit, and Deny.
Select the protocol type option here. Options to choose from are TCP, UDP,
ICMP, EIGRP (88), ESP (50), GRE (47), IGMP (2), OSPF (89), PIM (103),
VRRP (112), IP-in-IP (94), PCP (108), Protocol ID, and None.
281
Advertisement
Table of Contents
