D-Link VoiceCenter DVX-2000MS User Manual page 31

Section  - Installation
Now that you have the phones connected to the LAN and have configured them through Microsoft
Administrator, it's time to test the connection and configuration to make sure they work.
Note: You can dial extension numbers in several ways:
• Dial the number, and wait for several seconds before the connection is made.
• Dial the number, and press OK on the phone (for a faster connection time).
• Press Response Point button on the phone, and say the name of the person you want to call, in this
case the name of the phone user assigned to the phones you just configured.
To test the phones with the Microsoft Response Point phone system
1. Using the first phone, dial the extension number assigned to the user on the second phone, and confirm
that it rings.
Note: It may take several seconds for the second phone to ring.
2. Go to the second phone and try the extension number of the user on the first phone.
If the phones did not work, the likely cause is a loose connection. Make sure all cables and cords are properly seated
into their
respective ports, jacks, and outlets.
Next, you're going to configure the DVG-3104MS gateway.
D-Link DVX-000MS User Manual
Testing Two Response Point Phones
Response Point
® ™
1