Table of Contents
Advertisement
5-2. Servo/DT System Check Mode
b) C001: CASSETTE COMP. SW
This mode checks the functions of the sensors (switches) in the compartment
block.
Confirm that the corresponding switch number on the monitor screen changes to
"
" when switches SW1 through SW3 in the figure are pressed manually. Also
confirm that "
" changes to the corresponding number when they are released.
In case of NG;
When "
" is not displayed in the specified position or when the display does
not return from "
" to the corresponding number.
Check the corresponding sensors on the PC-70 board.
Also check the sensor input circuit on the DR-200 board.
5-12
SERVO CHECK
INPUT CHECK
C001:CASSETTE COMP. SW
SW1: CASSETTE IN SW 1
SW2: CASSETTE IN SW 2
SW3: LARGE CASSETTE SW
3
1
2
Advertisement
Table of Contents
