Operation To The Maintenance Mode - Sony DVW-522 Maintenance Manual

5-1. Outline

5-1-1. Operation to the Maintenance Mode

Activating the maintenance mode
(1) Confirm that the video monitor is connected to the VIDEO OUTPUT
COMPOSITE 2 connector or RF ADAPTOR VIDEO connector.
(2) Press the 8 S300 (SS board).
(3) The mode screen in the maintenance mode is displayed on the monitor screen.
Terminating the maintenance mode
(1) Press the 2 MENU button or 9 S301 (SS board) several times to display the
mode screen.
(2) Press the 2 MENU button or 9 S301 (SS board) again when the mode screen is
displayed. The maintenance mode is then exited.
Activating the maintenance mode on lower control panel
When the !/S100-7 (SS board) is set to ON (upper position), the maintenance mode
can be activated by the operation mentioned below.
(1) Press the 2 MENU button once.
(The mode then changes from operation mode to setup menu mode.)
(2) Press the 3 SET button while pressing the 4 CTL button.
(The mode then changes from setup menu mode to maintenance mode.)
(3) The mode screen in the maintenance mode is displayed on the monitor screen.
5-4
MAINTENANCE MODE
*C0 : SERVO/DT CHECK
C1 : RF CHECK
C2 : AUDIO/VIDEO CHECK
C4 : OTHERS CHECK
A0 : SERVO/DT ADJUST
A1 : RF ADJUST
A2 : AUDIO/VIDEO ADJUST
Mode Screen