5. Check that the shaft of the search dial is not seen in the
round hole of the mode selection plate and then tighten
the screw.
‹Back view›
B3x14
The shaft is not seen in the round hole.
The State that the Mode Cannot Be Switched
Mode selection plate
Round hole
Allowing search dial pressing to switch the mode
6. Perform the steps 1 to 3.
7. Slide the mode selection plate in the direction indicated
by the arrow until it touches the B portion.
8. Check that the shaft of the search dial is seen in the
round hole of the mode selection plate and then tighten
the screw.
‹Back view›
B3x14
B portion
The shaft is seen in the round hole.
Search dial shaft
The State that the Mode Can Be Switched
1-9. Search Dial Mode Switching
Mode selection plate
Round hole
1-15