Table of Contents
Advertisement
Blank panel installation
1. Remove the lower control panel assembly.
(Refer to Section 2-7.)
2. Fix the both arms at an angle of 45°.
3. Set the notches of the blank panel with the claws of the
each arm and tighten two screws until a click sounds.
n
Push the head of the two screws when the hook does
not move smoothly and when the panel is difficult to
set. This facilitates the setting.
Claws
Screw
B3x12
Notches
Blank panel
Installation of Blank Panel
Claws
Screw
B3x12
Notches
Assembling of remote control unit
1. Pass the connector at the end of the remote cable with a
15-pin connector through the control panel case and
tighten the screw of the cord stopper to fix.
2. Wind the harness clamper round a cable and fix the
cable so that it does not move.
Cable
Harness clamper
Fixing of Remote Cable
3. Loosen the two knob screws at the bottom of the
control panel case by one or two turns.
Control panel case
Turning of Knob Screws
1-10. Installation of BKDW-510/511
BV3x8
Cord stopper
Control panel case
Knob screws
1-17
Advertisement
Table of Contents
