Panasonic MICRO-IMAGECHECKER AX40 User Manual page 98

7. Select "Detect Position".
Select "Front", "Peak", "Plural", or "Front/Rear" from the menu.
Detect Position:
Sets which edge is detected when there are multiple parts matching the conditions.
Settings of Detection
Position
Front
Peak
Plural
Front/ Rear
8. Select "OK Judge. Max." and press the ENTER key.
The value shown at the right of "OK Judge. Max." is highlighted.
OK Judge Max./ Min.
These are the standard values for the detected edges. If the detected edges are within the range between
maximum and minimum, it will be judged "OK".
9. Specify the values for "OK Judge. Max. " and "OK Judge. Min.".
10. Press the A key to begin to test.
Check for the results and X- /Y-coordinates which appear in the message area on the monitor screen.
If you output the judgement result to the external device, use the "Judgement Output" function
and if the measurement data, use the "Num. Calcu." function.
90
Edge to be detected
Outputs the nearest edge from
the start point.
Outputs the edge with the
highest differential value.
Outputs whole edges.
Outputs the nearest edge from
the start point and the end point.
Edge to be detected (for the
figure shown below.)
A (1 edge)
C (1 edge)
A - F (6 edges)
A and F (2 edges)