Mitsubishi Electric MELSEC Q Series User Manual page 483

Number Name
SD5
Common error Common error
to
information information
SD15
Description
• Common information corresponding to the error code (SD0) is
stored.
• The following three types of information are stored.
• Common error information type can be determined by "Common
information category code" in SD4.
(The value of the Common information category code stored in SD4
corresponds to 1),3), and 7) below.)
Module No..
No.
SD5
SD6
SD7
SD8
SD9
SD10
SD11
SD12
SD13
SD14
SD15
*1 : For multiple CPU systems, the slot No. or CPU No. is stored,
depending on the error.
(Regarding which number is stored, refer to each error code.)
No. 1 CPU: 1, No. 2 CPU: 2, No. 3 CPU: 3, No. 4 CPU: 4
*2 : Definition of the base No. and slot No.
<Base No.>
The value to identify the base unit mounted on the C Controller
module.
The definition of the base No. is shown in the following table.
BaseNo.
0
1 to 7
<Slot No.>
This value to identify the slot of each base unit and the module inserted
in the slot.
• I/O slot 0 (the right side of slot for the CPU slot) of the main
base unit is the slot of "Slot No. = 0".
• The slot No. order is the main base unit, the extension base
unit numbers 1 to 7 in that order, and a serial number is
assigned to each slot of each base unit.
• If I/O assignment of Setting/monitoring tools for the C
Controller module is used to set the number of slots in the
base unit, slot numbers are assigned for the set number of
slots.
*3 : When FFFF
identifiable, so specify the faulty sections in SD5.
*4 : If the slot No. does not exist in the module No., FF
Time (setting value)
No.
SD5
SD6 Hr.: in units of 1ms (0 to 65535ms)
SD7
SD8
SD9
SD10
SD11
SD12
SD13
SD14
SD15
Detailed description
Item
Slot No./CPU No./BaseNo. *1, *2, *4
I/O No. *3
(Empty)
Definition
Indicates the main base unit which a CPU module is mounted.
Indicates an extension base unit.
The stage number setting by a base number setting connector
of extension base unit turn to be Base No.
When a stage number setting is the first stage of extension
module: Base No. = 1
When a stage number setting is the seventh stage of
extension module: Base No. = 7
is stored in SD6 (I/O No.), the I/O No. is not
H
Item
(Empty)
(Empty)
APPENDICES
Setting side
(setting time)
S
(Error)
is stored.
H
481
A