Installing/Uninstalling And Unmounting A Compactflash Card - Mitsubishi Electric MELSEC Q Series User Manual

8.5
Installing/uninstalling and unmounting a CompactFlash
card
This section describes the procedures of inserting/removing a CompactFlash card into the C Controller module.
● Before handling a CompactFlash card, touch a grounded metal object to discharge the static electricity from the human
body. Failure to do so may cause failure of the module or malfunction.
● If the CompactFlash card is not installed/uninstalled properly as follow the procedure in this section, data corruption or file
error in the CompactFlash card may occur.
● Do not operate the following operations during accessing to the CompactFlash card.
• Turn the power OFF
• Reset
(1) Installation procedure
Front cover
1) Open the front cover
CompactFlash card slot
EJECT button
Orientation of
CompactFlash
card
CompactFlash card slot
● If a CompactFlash card is already inserted when the power is up, it is automatically mounted.
● Any unmounted CompactFlash card cannot be used with the CF CARD LED turned off. In such case, remove and then
insert it again. To make it usable without removing it, use the CCPU_MountMemoryCard function from the user program
to mount the CompactFlash card.
122
EJECT button
2) Press the
EJECT button.
Dummy
CompactFlash card
CompactFlash card
Projected
part
Q24DHC-V Q24DHC-VG Q24DHC-LS
1.
Pull the section labeled as "PULL" on the front
cover to open the cover.
2.
Press the EJECT button to remove the dummy
CompactFlash card.
Please keep the removed dummy CompactFlash
card in a secure location.
3.
Insert a CompactFlash card into the
CompactFlash card installation slot.
When inserting a CompactFlash card, pay
attention to its orientation.
Insert the CompactFlash card into the installation
slot and push it until the card edge is flush with the
EJECT button.
4.
Close the C Controller module front cover until
it clicks.
5.
Check if the CF CARD LED turns ON.
Q26DHC-LS
Q12DC-V