Install 3.5" Disk Drive In The Carrier - Bosch CIP5000 Series User Manual

24 en | Hardware configuration
Caution!
The CIP5000 models support hot-swapping disk drives.
!
To avoid hand contact with an electrical hazard, remove only one drive carrier at a time.
Figure 5.9: Disk carrier with HDD installed (front view)
5.3.3

Install 3.5" disk drive in the carrier

Obey the following instructions to install 3.5" hard disk drives into the drive carriers.
1.
2.
3.
4.
Repeat steps 1 through 3 until all of your disk drives are installed.
2019-10 | V01 | F.01U.380.030
Push here when returning
or replacing the carrier into
an empty drive bay.
Remove a disk drive carrier.
Carefully lay the disk drive into the drive carrier at the front, so that the screw holes on
the sides line up correctly with the power and data connectors facing away from the
carrier handle.
Insert the screws through the holes in the drive carrier and into the sides of the disk
drive.
– Install only the counter-sink screws supplied with the drive.
– Install four screws per drive.
– Snug each screw. Be careful not to over-tighten.
Reinstall the drive carrier into the enclosure.
Pull here to release the carrier handle latch.
Then pull the carrier straight out by the handle.
Place your free hand under the carrier.
Do not drop the disk carrier, even if it is empty.
User manual
CIP5000 series storage
Bosch Security Systems B.V.